BCA3030-UNDERSTANDING PC & TROUBLE SHOOTING

Dear students get fully solved  assignments
Send your semester & Specialization name to our mail id :

“ help.mbaassignments@gmail.com ”
or
Call us at : 08263069601



ASSIGNMENT

DRIVE
SUMMER 2015
PROGRAM
BCA(REVISED FALL 2012)
Semester
3
SUBJECT CODE & NAME
BCA3030-UNDERSTANDING PC & TROUBLE SHOOTING
CREDIT
4
BK ID
B 1416
MAX.MARKS
60


Note: Answer all questions. Kindly note that answers for 10 marks questions should be approximately of 400 words. Each question is followed by evaluation scheme.



1. What are processor modes? Explain the three types of processor modes.

Answer: Processor modes refer to the various ways that the processor creates an operating environment for itself. Specifically, the processor mode controls how the processor sees and manages the system memory and the tasks that use it. There are three different modes of operation, which resulted from the evolution of the PC from its humble beginnings with the Intel 8088 chip.

Real Mode: The original IBM PC could only address 1 MB of system memory, and the original versions of DOS created to work on it were designed with this in mind. DOS is by its nature a single-tasking operating system, meaning it can only handle one program running at a time. The decisions made in these early days have carried forward until




Q.2  List the different PCI signals along with their functions?

Answer : The PCI bus is the de-facto standard bus for current-generation personal computers. The mainadvantages for embedded applications like the STT are:

·         direct implementation in FPGAs (no data buffers or glue chips)
·         efficient protocol ("data burst" is the standard transfer)
·         ready availability of development hardware (




Q.3 Define the following.

a. Front Sided Bus

Answer: A front-side bus (FSB) was a computer communication interface (bus) often used in Intel-chip-based computers during the 1990s and 2000s. The competing EV6 bus served the same function for AMD CPUs. Both typically carry data between the central processing unit (CPU) and a memory controller hub, known as the Northbridge.

Depending on the implementation, some






Q4. What is POST? What are the various steps performed by the POST to check for resource availability.

Answer: A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.

This article mainly deals with personal computers, but many other embedded systems such as those in major appliances, avionics, communications, or medical equipment also have self-test routines which are automatically invoked at power-on.




Q. 5 Discuss any five guidelines that we need to follow while troubleshooting the hardware problem.
Answer: The term troubleshooting refers to the act of applying diagnostic tools--often heuristically and accompanied by common sense--to determine the causes of system problems.
Each system problem must be treated on its own merits. It is not possible to provide a cookbook of actions that resolve each problem. However, this chapter provides some approaches and procedures, which used in combination with experience and common sense, can resolve many problems that might arise. Troubleshooting is a form of problem solving,





Q6. List the steps involved in installation of software in modem.

Answer: Make sure the modem can work with your service provider. While uncommon, sometimes you might run into an issue where the modem you purchased isn't compatible with the internet service available in your area.

Installation: Remove your old modem. Remember to uninstall any drivers associated with your old modem and reset your computer after doing so. Also, keep the cables since you might need them for your new modem.



Dear students get fully solved  assignments
Send your semester & Specialization name to our mail id :

“ help.mbaassignments@gmail.com ”
or
Call us at : 08263069601


No comments:

Post a Comment

Note: only a member of this blog may post a comment.